Enterasys G3G170-24 - Clear Rmon History; Alarm Group Commands; Purpose

clear rmon history
Enterasys G-Series CLI Reference 12-7
Defaults
Ifbucketsisnotspecified,themaximumnumberofentriesmaintainedwillbe50.
Ifnotspecified,intervalwillbesetto30seconds.
Ifownerisnotspecified,monitorwillbeapplied.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowconfigureRMONhistoryentry1onportge.2.1tosampleevery20
seconds:
G3(rw)->set rmon history 1 ge.2.1 interval 20
clear rmon history
UsethiscommandtodeleteoneormoreRMONhistoryentriesorresetoneormoreentriesto
defaultvalues.Forspecificvalues,referto“setrmonhistory”onpage 12‐6.
Syntax
clear rmon history {index-list | to-defaults}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtodeleteRMONhistoryentry1:
G3(rw)->clear rmon history 1
Alarm Group Commands
Purpose
Todisplay,configure,andclearRMONalarmentriesandproperties.
index‐list Specifiesoneormorehistoryentriestobedeleted,causingthemto
disappearfromanyfutureRM ONqueries.
to‐defaults Resetsallhistoryentriestodefaultvalues.Thiswillcauseentriesto
reappearinRMONqueries.