Enterasys G3G170-24 - Set Width; Set Length

set width
2-24 Basic Configuration
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosetthesystemcontactstring:
G3(su)->set system contact “Joe Smith”
set width
Usethiscommand tosetthenumberofcolumnsfor theterminalconnectedtotheswitch’sconsole
port.
Syntax
set width screenwidth [default]
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
ThenumberofrowsofCLIoutputdisplayedissetusingthesetlengthcommandasdescribedin
“setlength”onpage2‐24.
Example
Thisexampleshowshowtosettheterminalcolumnsto50:
G3(su)->set width 50
set length
UsethiscommandtosetthenumberoflinestheCLIwilldisplay.Thiscommandispersistent
(writtentoNV‐RAM).
Syntax
set length screenlength
screenwidth Setsthenumberofterminalcolumns.Validvaluesare50to150.
default (Optional)Makesthissettingpersistentforallfuturesessions(writtento
NV‐RAM).