Enterasys G3G170-24 - Configuring Port Web Authentication (PWA); About PWA; Commands; Purpose

Configuring Port Web Authentication (PWA)
Enterasys G-Series CLI Reference 20-57
Configuring Port Web Authentication (PWA)
About PWA
PWAprovidesawayofauthenticatingusersbeforeallowinggeneralaccesstothenetwork
TologonusingPWA,theusermakesarequestthroughawebbrowserforthePWAwebpageor
isautomaticallyredirectedtothisloginpageafterrequestingaURLinabrowser.
Dependinguponthe
authenticatedstateoftheuser,aloginpageoralogoutpagewilldisplay.
Whenausersubmitsusernameandpassword,theswi tchthenauthenticatestheuserviaa
preconfiguredRADIUSserver.Iftheloginissuccessful,thentheuserwillbegrantedfullnetwork
accessaccordingtotheuser’s
policyconfigurationontheswitch.
Purpose
Toreview,enable,disable,andconfigurePortWebAuthentication(PWA).
Commands
PWA PWA
Note: One user per PWA-configured port can be authenticated on G-Series devices.
PWA authentication does not support RFC-3580 VLAN authorization.
For information about... Refer to page...
show pwa 20-58
set pwa 20-59
show pwa banner 20-60
set pwa banner 20-60
clear pwa banner 20-61
set pwa displaylogo 20-61
set pwa ipaddress 20-62
set pwa protocol 20-62
set pwa guestname 20-63
clear pwa guestname 20-63
set pwa guestpassword 20-64
set pwa gueststatus 20-64
set pwa initialize 20-65
set pwa quietperiod 20-65
set pwa maxrequest 20-66
set pwa portcontrol 20-66
show pwa session 20-67
set pwa enhancedmode 20-68