Enterasys G3G170-24 - Interface Configuration Commands; Purpose; Commands; Ipv6 Ospf Enable

Interface Configuration Commands
19-20 OSPFv3 Configuration
Example
Thisexamplesetsthetransmitdelayto2secondsforthespecifiedOSPFv3virtualinterface.
G3(su)->router(Config-router)# area 20 virtual-link 2.2.2.2 transmit-delay 2
Interface Configuration Commands
Purpose
ThesecommandscanbeusedtoconfigureOSPFv3routinginterfaceparameters.
Commands
ipv6 ospf enable
ThiscommandenablesOSPFv3onarouterinterfaceoraloopbackinterface.
Syntax
ipv6 ospf enable
no ipv6 ospf enable
Parameters
None.
Defaults
OSPFv3isdisabledbydefault.
Mode
Routerinterfaceconfiguration:G3(su)‐>router(Config‐if(Vlan1))#
For information about... Refer to page...
ipv6 ospf enable 19-20
ipv6 ospf areaid 19-21
ipv6 ospf cost 19-22
ipv6 ospf dead-interval 19-22
ipv6 ospf hello-interval 19-23
ipv6 ospf mtu-ignore 19-24
ipv6 ospf network 19-24
ipv6 ospf priority 19-25
ipv6 ospf retransmit-interval 19-26
ipv6 ospf transmit-delay 19-26