Enterasys G3G170-24 - Configuring Simple Network Time Protocol (SNTP); Purpose; Show Sntp

Configuring Simple Network Time Protocol (SNTP)
Enterasys G-Series CLI Reference 11-25
Configuring Simple Network Time Protocol (SNTP)
Purpose
ToconfiguretheSimpleNetworkTimeProtocol(SNTP),whichsynchronizesdeviceclocksina
network.
Commands
show sntp
UsethiscommandtodisplaySNTPclientsettings.
Syntax
show sntp
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Note: A host IP address must be configured on the G3 to support SNTP.
For information about... Refer to page...
show sntp 11-25
set sntp client 11-27
clear sntp client 11-27
set sntp server 11-28
clear sntp server 11-28
set sntp poll-interval 11-29
clear sntp poll-interval 11-29
set sntp poll-retry 11-29
clear sntp poll-retry 11-30
set sntp poll-timeout 11-30
clear sntp poll-timeout 11-31