Enterasys G3G170-24 - Configuring IRDP; Commands; Ip Irdp Enable; Purpose

Configuring IRDP
16-34 IPv4 Routing Protocol Configuration
Example
ThisexampleshowshowtodisplayDVMRPstatusinformation:
G3(su)->router#show ip dvmrp
Vlan Id Metric Admin Status Oper. Status
------- ------- ------------ ------------
10 Enabled Enabled
18 Enabled Enabled
20 Enabled Enabled
25 Enabled Enabled
32 Enabled Enabled
500 Enabled Disabled
Configuring IRDP
Purpose
ToenableandconfiguretheICMPRouterDiscoveryProtocol(IRDP)onaninterface.This
protocolenablesahosttodeterminetheaddressofarouteritcanuseasadefaultgateway.Itis
disabledbydefault.
Commands
ip irdp enable
UsethiscommandtoenableIRDPonaninterface.Thenoformofthiscom manddisablesIRDPon
aninterface.
Syntax
ip irdp enable
no ip irdp enable
Parameters
None.
Defaults
None.
For information about... Refer to page...
ip irdp enable 16-34
ip irdp maxadvertinterval 16-35
ip irdp minadvertinterval 16-35
ip irdp holdtime 16-36
ip irdp preference 16-36
ip irdp broadcast 16-37
show ip irdp 16-38