Enterasys G3G170-24 - Commands; Show Port; Show Port Status

show port
4-4 Port Configuration
Commands
Thecommandsusedtoreviewportstatusarelistedbelow.
show port
Usethiscommandtodisplaywhetherornotoneormoreportsareenabledforswitching.
Syntax
show port [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,operationalstatusinformationforallportswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplayoperationalstatusinformationforge.3.14:
G3(su)->show port ge.3.14
Port ge.3.14 enabled
show port status
Usethiscommandtodisplayoperatingandadminstatus,speed,duplexmodeandporttypefor
oneormoreportsonthedevice.
Syntax
show port status [port-string]
Parameters
For information about... Refer to page...
show port 4-4
show port status 4-4
show port counters 4-5
port‐string (Optional)Displaysoperationalstatusforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage4‐1.
port‐string (Optional)Displaysstatus forspecificport(s).Foradetaileddescriptionof
possibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”on
page4‐1.