Enterasys G3G170-24 - Set Port Priority; Show Port Priority

show port priority
9-2 Port Priority Configuration
Commands
show port priority
Usethiscommandtodisplaythe802.1Dpriority foroneormoreports.
Syntax
show port priority [port-string]
Parameters
Defaults
If port-string is not specified, priority for all ports will be displayed.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaytheportpriorityforthege.2.1through5.
G3(su)->show port priority ge.2.1-5
ge.2.1 is set to 0
ge.2.2 is set to 0
ge.2.3 is set to 0
ge.2.4 is set to 0
ge.2.5 is set to 0
set port priority
Usethiscommandtosetthe802.1D(802.1p)Class‐of‐Servicetransmitpriority(0 through 7)on
eachport.Aportreceivingaframewithoutpriorityinformationinitstagheaderisassigneda
priorityaccordingtotheprioritysettingontheport.Forexample,ifthepriorityofaportisset
to
5,theframesreceivedthroughthat portwithout apriorityindicatedintheirtagheaderare
classifiedasapriority5.
Aframewithpriorityinformationinitstagheaderistransmittedaccordingtothatpriority.
Syntax
set port priority port-string priority
For information about... Refer to page...
show port priority 9-4
set port priority 9-2
clear port priority 9-3
port‐string (Optional)Displayspriorityinformationforaspecificport.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage 4‐1.