Enterasys G3G170-24 - Set Spantree Msti; Clear Spantree Msti

set spantree msti
6-12 Spanning Tree Configuration
Syntax
show spantree mstilist
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayalistofMSTinstances.Inthiscase,SID2hasbeenconfigured:
G3(su)->show spantree mstilist
Configured Multiple Spanning Tree instances:
2
set spantree msti
UsethiscommandtocreateordeleteaMultipleSpanningTreeinstance.
Syntax
set spantree msti sid sid {create | delete}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtocreateanMSTinstance2:
G3(su)->set spantree msti sid 2 create
clear spantree msti
UsethiscommandtodeleteoneormoreMultipleSpanningTreeinstances.
sidsid SetstheMultipleSpanningTreeID.Validvaluesare 1‐4094.
G‐Seriesdeviceswillsupportupto4MSTinstances.
create|delete CreatesordeletesanMSTinstance.