Enterasys G3G170-24 - Set Vlanauthorization

set vlanauthorization
Enterasys G-Series CLI Reference 20-43
Parameters
Defaults
Settopolicy.
Mode
Switchcommand,read‐write.
Examples
Thisexampleshowshowtosetthepolicymaptableresponsetotunnel:
G3(rw)-> set policy maptable response tunnel
set vlanauthorization
EnableordisabletheuseoftheRADIUSVLANtunnelattributetoputaportintoaparticular
VLANbasedontheresultofauthentication.
Syntax
set vlanauthorization {enable | disable} [port-string]
Parameters
Defaults
VLANauthenticationisdisabledbydefault.
Mode
Switchcommand,read‐write.
Examples
ThisexampleshowshowtoenableVLANauthenticationforallGigabitEthernetports:
G3(rw)-> set vlanauthorization enable ge.*.*
ThisexampleshowshowtodisableVLANauthenticationforallGigabitEthernetportsonswitch
unit/module 3:
G3(rw)-> set vlanauthorization disable ge.3.*
policy Setsthemaptableresponsetopolicy.Thisisthedefaultsetting,which
allowsauthenticationofupto8multiauthusersperport.
tunnel Setsthemaptableresponsetotunnel,whichallowsauthenticationofup
to8multiauthusersperport.ThissettingisrequiredtoconfigureVLAN
authorizationformultipleusers
perGigabitport.
enable|disable Enablesordisablesvlanauthorization/tunnelattributes.
port‐string (Optional)SpecifieswhichportstoenableordisabletheuseofVLAN
tunnelattributes/authorization.Foradetaileddescriptionofpossibleport‐
stringvalues,referto“PortStringSyntax UsedintheCLI”onpage 4‐1.