Enterasys G3G170-24 - Clear Rmon Capture

clear rmon capture
12-22 RMON Configuration
Defaults
Ifnotspecified,actiondefaultstolock.
Ifnotspecified,offsetdefaultsto0.
Ifnotspecified,asksizedefaultsto‐1(whichwillrequestasmanyoctetsaspossible).
Ifsliceisnotspecified,1 518willbeapplied.
Ifloadsizeisnotspecified,100willbeapplied.
Ifownerisnotspecified,
itwillbesettomonitor.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtocreateRMON captureentry1to“listen”onchannel62 8:
G3(rw)->set rmon capture 1 628
clear rmon capture
UsethiscommandtoclearsanRMONcaptureentry.
Syntax
clear rmon capture index
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoclearRMONcaptureentry1:
G3(rw)->clear rmon capture 1
index Specifiesthecaptureentrytobecleared.