Enterasys G3G170-24 - Show Ipv6 Neighbors

show ipv6 neighbors
Enterasys G-Series CLI Reference 18-21
Examples
ThisexampledisplaysinformationaboutIPv6interfaceVLAN7.
G3(su)->router>show ipv6 interface vlan 7
Vlan 7 Administrative Mode Enabled
Vlan 7 IPv6 Routing Operational Mode Enabled
IPv6 is Enabled
IPv6 Prefix is FE80::211:88FF:FE55:4A7F/128
3FFE:501:FFFF:101:211:88FF:FE55:4A7F/64
3FFD::211:88FF:FE55:4A7F/64
Routing Mode Enabled
Interface Maximum Transmit Unit 1500
Router Duplicate Address Detection Transmits 1
Router Advertisement NS Interval 0
Router Lifetime Interval 1800
Router Advertisement Reachable Time 0
Router Advertisement Interval 600
Router Advertisement Managed Config Flag Enabled
Router Advertisement Other Config Flag Enabled
Router Advertisement Suppress Flag Disabled
ThisexampledisplaysinformationaboutIPv6interfacetunnel1.
G3(su)->router>show ipv6 interface tunnel 1
Tunnel 1 Administrative Mode Enabled
Tunnel 1 IPv6 Routing Operational Mode Disabled
Mode for IPv6 Tunnel IPv6OVER4
Source Address for IPv6 Tunnel 192.168.1.2
Destination Address for IPv6 Tunnel 192.168.8.1
Routing Mode Enabled
Interface Maximum Transmit Unit 1480
Router Duplicate Address Detection Transmits 1
Router Advertisement NS Interval 0
Router Lifetime Interval 1800
Router Advertisement Reachable Time 0
Router Advertisement Interval 600
Router Advertisement Managed Config Flag Disabled
Router Advertisement Other Config Flag Disabled
Router Advertisement Suppress Flag Disabled
show ipv6 neighbors
ThiscommanddisplaysIPv6NeighborCacheinformation.
Syntax
show ipv6 neighbors
Parameters
None.
Defaults
None.
Mode
Routerprivilegedexecution:G3(su)‐>router#