Enterasys G3G170-24 - Show Pwa Session

show pwa session
Enterasys G-Series CLI Reference 20-67
Defaults
Ifport‐stringisnotspecified,PWAwillenabledonallports.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoenablePWAonports1‐22:
G3(su)->set pwa portcontrol enable ge.1.1-22
show pwa session
UsethiscommandtodisplayinformationaboutcurrentPWAsessions.
Syntax
show pwa session [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,sessioninformationforallportswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayPWAsessioninformation:
G3(su)->show pwa session
Port MAC IP User Duration Status
-------- ----------------- --------------- ------------- ------------ ---------
ge.2.19 00-c0-4f-20-05-4b 172.50.15.121 pwachap10 0,14:46:55 active
ge.2.19 00-c0-4f-24-51-70 172.50.15.120 pwachap1 0,15:43:30 active
ge.2.19 00-00-f8-78-9c-a7 172.50.15.61 pwachap11 0,14:47:58 active
port‐string (Optional)Setsthecontrolmodeonspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage 4‐1.
port‐string (Optional)DisplaysPWAsessioninformationforspecificport(s).Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐1.