Enterasys G3G170-24 - Configuring SNMP Target Addresses; Commands; Purpose; Show Snmp Targetaddr

Configuring SNMP Target Addresses
Enterasys G-Series CLI Reference 5-25
Example
ThisexampleshowshowtoclearSNMPtargetparametersnamed“v1ExampleParams”:
G3(su)->clear snmp targetparams v1ExampleParams
Configuring SNMP Target Addresses
Purpose
ToreviewandconfigureSNMPtargetaddresseswhichwillreceiveSNMPnotificationmessages.
AnaddressconfigurationcanbelinkedtooptionalSNMPtransmit,ortarget,parameters(suchas
timeout,retrycount,andUDPport)setwiththesetsnmptargetparamscommand((page5‐23)).
Commands
show snmp targetaddr
UsethiscommandtodisplaySNMPtargetaddressinformation.
Syntax
show snmp targetaddr [targetAddr] [volatile | nonvolatile | read-only]
Parameters
Defaults
IftargetAddrisnotspecified,entriesforalltargetaddressnameswillbedisplayed.
Ifnotspecified,entriesofallstoragetypeswillbedisplayedforatargetaddress.
Mode
Switchcommand,read‐only.
For information about... Refer to page...
show snmp targetaddr 5-25
set snmp targetaddr 5-26
clear snmp targetaddr 5-27
targetAddr (Optional)Displaysinformationforaspecifictargetaddressname.
volatile|nonvolatile
|read‐only
(Optional)Whentargetaddressisspecified,displaystargetaddress
informationforaspecificstoragetype.