Enterasys G3G170-24 - Show Maclock; Show Maclock Output Details

show maclock
Enterasys G-Series CLI Reference 20-47
show maclock
UsethiscommandtodisplaythestatusofMAClockingononeormoreports.
Syntax
show maclock [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,MAClockingstatuswillbedisplayedforallports.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayMAClockinginformationforge.1.1.
G3(su)->show maclock ge.1.1
MAC locking is globally enabled
Port Port Trap Aging Max Static Max FirstArrival Last Violating
Number Status Status Status Allocated Allocated MAC Address
------- ------- -------- ------- ---------- --------------- ---------------
ge.1.1 enabled disabled enabled 20 1 00:a0:c9:39:5c:b4
Table 20‐6providesanexplanationofthecommandoutput.
set maclock static 20-52
clear maclock static 20-52
set maclock firstarrival 20-53
clear maclock firstarrival 20-54
set maclock agefirstarrival 20-54
clear maclock agefirstarrival 20-55
set maclock move 20-55
set maclock trap 20-56
For information about... Refer to page...
port‐string (Optional)DisplaysMAClockingstatusforspecifiedp ort(s).Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐1.
Table 20-6 show maclock Output Details
Output Field What It Displays...
Port Number Port designation. For a detailed description of possible port-string values, refer to
“Port String Syntax Used in the CLI” on page 4-1.