Enterasys G3G170-24 - Ip Ospf Retransmit-Interval; Ip Ospf Transmit-Delay

ip ospf retransmit-interval
16-16 IPv4 Routing Protocol Configuration
ip ospf retransmit-interval
Usethiscommandtosettheamountoftimebetweenretransmissionsoflinkstateadvertisements
(LSAs)foradjacenciesthatbelongtoaninterface.Thenoformofthiscommandresetsthe
retransmitintervalvaluetothedefault,5seconds.
Syntax
ip ospf retransmit-interval seconds
no ip ospf retransmit-interval
Parameters
Defaults
None.
Mode
Interfaceconfiguration:G3(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtosettheOSPFretransmitintervalfortheVLAN1interfaceto20:
G3(su)->router(Config)#interface vlan 1
G3(su)->router(Config-if(Vlan 1))#ip ospf retransmit-interval 20
ip ospf transmit-delay
Usethiscommandtosettheamountoftimerequiredtotransmitalinkstateupdatepacketonan
interface.Thenoformofthiscommandresetstheretransmitintervalvaluetothedefault,1
second.
Syntax
ip ospf transmit-delay seconds
no ip ospf transmit-delay
Parameters
Defaults
None.
Mode
Interfaceconfiguration:G3(su)‐>router(Config‐if(Vlan1))#
Example
Thisexampleshowshowtosetthetimerequiredtotransmitalinkstateupdat epacketonthe
VLAN1interfaceat20seconds:
G3(su)->router(Config)#interface vlan 1
G3(su)->router(Config-if(Vlan 1))#ip ospf transmit-delay 20
seconds Specifiestheretransmittimeinseconds.Validvaluesare1to65535.
seconds Specifiesthetransmitdelayinseconds.Validvaluesarefrom1to65535.