show ipv6 ospf interface stats
19-38 OSPFv3 Configuration
show ipv6 ospf interface stats
Thiscommanddisplaysstatisticsforaspecificinterface.StatisticsaredisplayedonlyifOSPFv3is
enabled.
Syntax
show ipv6 ospf interface stats vlan vlanid
Parameters
Defaults
None.
Mode
Routerprivilegedexecution:G3(su)‐>router#
Retransmit Interval The frequency, in seconds, at which the interface sends LSA.
Hello Interval The frequency, in seconds, at which the interface sends Hello
packets.
Dead Interval The amount of time, in seconds, the interface waits before
assuming a neighbor is down.
LSA Ack Interval The amount of time, in seconds, the interface waits before
sending an LSA acknowledgement after receiving an LSA.
Iftransit Delay Interval The number of seconds the interface adds to the age of LSA
packets before transmission.
Authentication Type The type of authentication the interface performs on LSAs it
receives.
Metric Cost The priority of the path. Low costs have a higher priority than high
costs.
OSPF MTU-ignore Whether to ignore MTU mismatches in database descriptor
packets sent from neighboring routers. The following information
only displays if OSPF is initialized on the interface:
OSPF Interface Type Broadcast LANs, such as Ethernet and IEEE 802.5, take the value
broadcast. Tunnel interfaces take the value point-to-point.
State The OSPF Interface States are: down, loopback, waiting, point-to-
point, designated router, and backup designated router.
Designated Router The router ID representing the designated router.
Backup Designated Router The router ID representing the backup designated router.
Number of Link Events The number of link events.
Table 19-7 show ipv6 ospf interface Command Output Details (Continued)
Output Field What It Displays...
vlanvlanid SpecifiestheVLANinterfaceforwhichtodisplaystatistics.
To Next Page
Loading...
