Enterasys G3G170-24 - Ip Igmp Query-Interval; Ip Igmp Query-Max-Response-Time

ip igmp query-interval
Enterasys G-Series CLI Reference 10-13
ip igmp query-interval
UsethiscommandtosettheIGMPqueryintervalonaroutinginterface.Thenoformofthis
commandresetstheIGMPqueryintervaltothedefaultvalueof125seconds.
Syntax
ip igmp query-interval time
no ip igmp query-interval
Parameters
Defaults
None.
Mode
Interfaceconfiguration:G3(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtosettheIGMPqueryintervalto1800secondsonVLAN1:
G3(su)->router(Config)#interface vlan 1
G3(su)->router(Config-if(Vlan 1))#ip igmp query-interval 1800
ip igmp query-max-response-time
UsethiscommandtosetthemaximumresponsetimeintervaladvertisedinIGMPv2queries.The
no form of this command resets the IGMP maximum response time to the default value of 100
(one tenth of a second).
Syntax
ip igmp query-max-response-time time
no ip igmp query-max-response-time
Parameters
Defaults
None.
Mode
Interfaceconfiguration:G3(su)‐>router(Config‐if(Vlan1))#
time SpecifiestheIGMPqueryinterval.Validvaluesarefrom1to3600
seconds.Defaultis125 seconds.
time SpecifiestheIGMPmaximumresponsetimeint erval.Validvaluesare
from0to255tenthsofasecond.
The default value is 100 (one tenth of a
second).