Enterasys G3G170-24 - Clear Radius Accounting

clear radius accounting
Enterasys G-Series CLI Reference 20-9
Examples
ThisexampleshowshowtoenabletheRADIUSaccountingclientforauthenticatingwiththe
accountingserveratIPaddress10.2.4.12,UDPauthenticationport1800.Aspreviouslynoted,the
“serversecret”passwordenteredheremustmatchthatalreadyconfiguredastheRead‐Write(rw)
passwordontheRADIUSaccountingserver:
G3(su)->set radius accounting server 10.2.4.12 1800
Enter secret:
Re-enter secret:
ThisexampleshowshowtosettheRADIUSaccountingtimeoutto30seconds:
G3(su)->set radius accounting timeout 30
ThisexampleshowshowtosetRADIUSaccountingretriesto10:
G3(su)->set radius accounting retries 10
clear radius accounting
UsethiscommandtoclearRADIUSaccountingconfigurationsettings.
Syntax
clear radius accounting {server ip-address | retries | timeout | counter}
Parameters
Mode
Switchcommand,read‐write.
Defaults
None.
Example
ThisexampleshowshowtoresettheRADI USaccountingtimeoutto5seconds.
G3(su)->clear radius accounting timeout
serverip‐address Clearstheconfigurationononeormoreaccountingservers.
retries Resetstheretriestothedefaultvalueof3.
timeout Resetsthetimeoutto5seconds.
counter Clearscounters.