Enterasys G3G170-24 - General Configuration Commands; Ipv6 Forwarding; Ipv6 Hop-Limit

General Configuration Commands
Enterasys G-Series CLI Reference 18-3
General Configuration Commands
ipv6 forwarding
ThiscommandenablesordisablesIPv6forwardingontherouter.
Syntax
ipv6 forwarding
no ipv6 forwarding
Parameters
None.
Defaults
IPv6forwardingisenabled.
Mode
Routerglobalconfiguration:G3(su)‐>router(Config)#
Usage
ThenoformofthiscommanddisablesIPv6forwardingonthe router.
Example
ThisexampledisablesIPv6forwarding.
G3(su)->router(Config)# no ipv6 forwarding
ipv6 hop-limit
ThiscommandsetsthemaximumnumberofIPv6hopsusedinIPv6packetsandrouter
advertisementsgeneratedbythisdevice.
Syntax
ipv6 hop-limit hops
no ipv6 hop-limit
For information about... Refer to page...
ipv6 forwarding 18-3
ipv6 hop-limit 18-3
ipv6 route 18-4
ipv6 route distance 18-5
ipv6 unicast-routing 18-6
ping ipv6 18-6
ping ipv6 interface 18-7
traceroute ipv6 18-8