Enterasys G3G170-24 - Clear Dhcp Pool Dns-Server; Set Dhcp Pool Domain-Name

clear dhcp pool dns-server
Enterasys G-Series CLI Reference 13-23
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleassignsaDNSserverat10.14.10.1totheaddresspool“‘auto1.”
G3(rw)->set dhcp pool auto1 dns-server 10.14.10.1
clear dhcp pool dns-server
UsethiscommandtoremovetheDNSserverlistfromtheaddresspoolbeingconfigured.
Syntax
clear dhcp pool poolname dns-server
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleremovestheDNSserverlistfromtheaddresspool“auto1.”
G3(rw)->clear dhcp pool auto1 dns-server
set dhcp pool domain-name
UsethiscommandtospecifyadomainnametobeassignedtoDHCPclientsservedbythe
addresspoolbeingconfigured.
Syntax
set dhcp pool poolname domain-name domain
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
address SpecifiestheIPaddressofaDNSserver.
address2...address8 (Optional)Specifies,inorderofpreference,upto7additionalDNS
serveraddresses.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.