Enterasys G3G170-24 - Set Spantree Spanguardtrapenable; Clear Spantree Spanguardtrapenable

set spantree spanguardtrapenable
Enterasys G-Series CLI Reference 6-29
Syntax
show spantree spanguardtrapenable
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaythestateoftheSpanGuardtrapfunction:
G3(ro)->show spantree spanguardtrapenable
Spanguard SNMP traps are enabled
set spantree spanguardtrapenable
UsethiscommandtoenableordisablethesendingofanSNMPtrapmessagewhenSpanGuard
haslockedaport.
Syntax
set spantree spanguardtrapenable {disable | enable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtodisabletheSpanGuardtrapfunction:
G3(su)->set spantree spanguardtrapenable disable
clear spantree spanguardtrapenable
UsethiscommandtoresettheSpanningTreeSpanGuardtrapfunctionbacktothedefaultstateof
enabled.
Syntax
clear spantree spanguardtrapenable
disable|enable DisablesorenablessendingSp anGuardtraps.Bydefault,sendingtraps
isenabled.