Enterasys G3G170-24 - Clear Multiauth Mode; Set Multiauth Precedence

clear multiauth mode
20-32 Security Configuration
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
MultiauthmultimoderequiresthatMAC,PWA,and802.1Xauthenticationbeenabledglobally,
andconfiguredappropriatelyonthedesiredportsaccordingtotheircorrespondingcommand
setsdescribedinthischapter.Referto“Configuring802.1XAuthentication”onpage 20‐10and
“ConfiguringMACAuthentication”onpage 20‐19and“ConfiguringPort
WebAuthentication
(PWA)”onpage 20‐57.
Example
Thisexampleshowshowtoenablesimultaneousmultipleauthentications:
G3(rw)->set multiauth mode multi
clear multiauth mode
Usethiscommandtoclearthesystemauthenticationmode.
Syntax
clear multiauth mode
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoclearthesystemauthenticationmode:
G3(rw)->clear multiauth mode
set multiauth precedence
Usethiscommandtosetthesystem’smultipleauthenticationadministrativeprecedence.
multi Allowsthesystemtousemultipleauthenticatorssimultaneously(802.1x,
PWA,andMACAuthentication)onaport.Thisisthedefaultmode.
strict Usermustauthenticateusing802.1xauthentica tionbeforenormaltraffic
(anythingotherthanauthenticationtraffic)canbeforwarded.