Enterasys G3G170-24 - Clear Dhcp Pool Default-Router; Set Dhcp Pool Dns-Server

clear dhcp pool default-router
13-22 DHCP Server Configuration
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleassignsadefaultrouterat10.10.1 0.1totheaddresspoolnamed“auto1.”
G3(rw)->set dhcp pool auto1 default-router 10.10.10.1
clear dhcp pool default-router
Usethiscommandtodeletethedefaultroutersconfiguredforthisaddresspool.
Syntax
clear dhcp pool poolname default-router
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleremovesthedefaultrouterfromtheaddresspool“auto1.”
G3(rw)->clear dhcp pool auto1 default-router
set dhcp pool dns-server
UsethiscommandtospecifyoneormoreDNSserversfortheDHCPclientsservedbytheaddress
poolbeingconfigured.Upto8DNSserverscanbeconfigured.
Syntax
set dhcp pool poolname dns-server address [address2 ... address8]
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
address SpecifiestheIPaddressofadefaultrouter.
address2...address8 (Optional)Specifies,inorderofpreference,upto7additionaldefault
routeraddresses.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.