Enterasys G3G170-24 - Ip Igmp Startup-Query-Count; Ip Igmp Startup-Query-Interval

ip igmp startup-query-interval
10-14 IGMP Configuration
Example
ThisexampleshowshowtosettheIGMPquerymaximumresponsetimeintervalto200(2tenths
ofasecond)onVLAN1:
G3(su)->router(Config)#interface vlan 1
G3(su)->router(Config-if(Vlan 1))#ip igmp query-max-response-time 200
ip igmp startup-query-interval
UsethiscommandtosettheintervalbetweengeneralIGMPqueriessentonstartup.Thenoform
ofthiscommandresetstheIGMPstartupqueryintervaltothedefaultvalueof31seconds.
Syntax
ip igmp startup-query-interval time
no ip igmp startup-query-interval
Parameters
Defaults
None.
Mode
Interfaceconfiguration:G3(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtosettheIGMPstartupqueryintervalto100secondsonVLAN1:
G3(su)->router(Config)#interface vlan 1
G3(su)->router(Config-if(Vlan 1))#ip igmp startup-query-interval 100
ip igmp startup-query-count
UsethiscommandtosetthenumberofIGMPqueriessentoutonstartup,separatedbythe
startup‐query‐interval(asdescribedin“ipigmpstartup‐query‐interval”onpage 10‐14).Theno
formofthiscommandresetstheIGMPstartupquerycounttothedefaultvalueof2.
Syntax
ip igmp startup-query-count count
no ip igmp startup-query-count
Parameters
Defaults
None.
time SpecifiestheIGMPstartupqueryinterval.Validvaluesarefrom1to300
seconds.Thedefaultvalueis31seconds.
count SpecifiesthenumberofIGMPstartupqueries.Validvaluesarefrom1to
20.Thedefaultvalueis2.