Enterasys G3G170-24 - Show Ipv6 Ospf Stub Table; Show Ipv6 Ospf Range Output Details; Show Ipv6 Ospf Stub Table Output Details

show ipv6 ospf stub table
Enterasys G-Series CLI Reference 19-43
Example
Thisexampledisplaysrangeinformationforarea20.
G3(su)->router#show ipv6 ospf range 20
Area ID IPv6 Prefix/Prefix Length Lsdb Type Advertisement
--------------- ------------------------- --------------- -------------
0.0.0.20 3345:1234::/64 Summary Link Enabled
Table 19‐11providesanexplanationofthecommandoutput.
show ipv6 ospf stub table
ThiscommanddisplaystheOSPFv3stubtable,ifOSPFv3isinitializedontheswitch.
Syntax
show ipv6 ospf stub table
Parameters
None.
Defaults
None.
Mode
Routerprivilegedexecution:G3(su)‐>router#
Example
ThisexampledisplaystheOSPFv3stubtable information.
G3(su)->router# show ipv6 ospf stub table
AreaId TypeofService Metric Val Import SummaryLSA
---------------- ------------- ---------- -----------------
0.0.0.20 Normal 1 Enable
Table 19‐12providesanexplanationofthecommandoutput.
Table 19-11 show ipv6 ospf range Output Details
Output Field What It Displays...
Area ID The area ID of the requested OSPFv3 area.
IPv6 Prefix/Prefix Length An IPv6 prefix and length which represents a configured area
range.
Lsdb Type The type of link advertisement associated with this area range.
Advertisement The status of the advertisement: enabled or disabled.
Table 19-12 show ipv6 ospf stub table Output Details
Output Field What It Displays...
Area ID A 32-bit identifier for the created stub area.
Type of Service Type of service associated with the stub metric. For this release,
Normal TOS is the only supported type.