Enterasys G3G170-24 - Commands; Set Host Vlan; Show Host Vlan

show host vlan
Enterasys G-Series CLI Reference 7-17
Commands
show host vlan
UsethiscommandtodisplaythecurrenthostVLAN.
Syntax
show host vlan
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaythehostVLAN:
G3(su)->show host vlan
Host vlan is 7.
set host vlan
UsethiscommandtoassignhoststatustoaVLAN.
Syntax
set host vlan vlan-id
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
For information about... Refer to page...
show host vlan 7-17
set host vlan 7-17
clear host vlan 7-18
vlan‐id SpecifiesthenumberoftheVLAN tosetasthehostVLAN.