Enterasys G3G170-24 - Set System Location; Set System Contact

set system location
Enterasys G-Series CLI Reference 2-23
Example
ThisexampleshowshowtosetthesystemnametoInformationSystems:
G3(su)->set system name “Information Systems”
set system location
Usethiscommandtoidentifythelocationofthesystem.
Syntax
set system location [string]
Parameters
Defaults
Ifstringisnotspecified,thelocationnamewillbecleared.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosetthesystemlocationstring:
G3(su)->set system location “Bldg N32-04 Closet 9”
set system contact
Usethiscommandtoidentifyacontactpersonforthesystem.
Syntax
set system contact [string]
Parameters
Defaults
Ifstringisnotspecified,thecontactnamewillbecleared.
string (Optional)Specifiesatextstringthatindicateswherethesystemis
located.
Note: A location string containing a space in the text must be
enclosed in quotes as shown in the example below.
string (Optional)Specifiesatextstringthatcontainsthenameofthepersonto
contactforsystemadministration.
Note: A contact string containing a space in the text must be enclosed
in quotes as shown in the example below.