Enterasys G3G170-24 - Clear Spantree Bridgeprioritymode; Show Spantree Mstilist

clear spantree bridgeprioritymode
Enterasys G-Series CLI Reference 6-11
Defaults
None
Mode
Switchcommand,read‐write.
Usage
Themodeaffectstherangeofpriorityvaluesusedtodeterminewhichdeviceisselectedasthe
SpanningTreerootasdescribedinsetspantreepriority(“setspantreepriority”onpage 6‐17).
Thedefaultfortheswitchistouse802.1tbridgeprioritymode.
Example
Thisexampleshowshowtosetthebridgeprioritymodeto802.1D:
G3(rw)->set spantree bridgeprioritymode 8021d
clear spantree bridgeprioritymode
UsethiscommandtoresettheSpanningTreebridgeprioritymodetothedefaultsettingof802.1t.
Syntax
clear spantree bridgeprioritymode
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoresetthebrid geprioritymodeto802.1t:
G3(rw)->clear spantree bridgeprioritymode
show spantree mstilist
UsethiscommandtodisplayalistofMultipleSpanning Tree(MST)instancesconfiguredonthe
device.
8021t Setsthebridgeprioritymodetouse802.1tvalues,whichare0to614 40,in
incrementsof4096.Valueswillautomaticallyberoundedupordown,
dependingonthe802.1tvaluetowhichthe
enteredvalueisclosest.
Thisisthedefaultbridgeprioritymode.