Enterasys G3G170-24 - Clear Spantree Lpwindow; Set Spantree Lptrapenable

clear spantree lpwindow
Enterasys G-Series CLI Reference 6-47
clear spantree lpwindow
UsethiscommandtoresettheLoopProtecteventwindowtothedefaultvalueof180seconds.
Syntax
clear spantree lpwindow
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoresettheLoopProtecteventwindowtothedefaultof180seconds:
G3(rw)->clear spantree lpwindow
set spantree lptrapenable
UsethiscommandtoenableordisableLoopProtecteventnotification.
Syntax
set spantree lptrapenable {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
LoopProtecttrapsaresentwhenaLoopProtecteventoccurs,thatis,whenaportgoestolistening
duetonotreceivingBPDUs.Thetrapindicatesport,SIDandloopprotectionstatus.
Example
ThisexampleshowshowtoenablesendingofLoopProtecttraps:
G3(rw)->set spantree lptrapenable enable
enable|disable EnablesordisablesthesendingofLoopProtecttraps.Defaultis
disabled.