Enterasys G3G170-24 - Clear Spantree Lpthreshold; Show Spantree Lpthreshold

show spantree lpthreshold
Enterasys G-Series CLI Reference 6-45
Example
ThisexampleshowshowtosettheLoopProtectthresholdvalueto4:
G3(rw)->set spantree lpthreshold 4
show spantree lpthreshold
UsethiscommandtodisplaythecurrentvalueoftheLoopProtecteventthreshold.
Syntax
show spantree lpthreshold
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaythecurrentLoopProtectthresholdvalue:
G3(rw)->show spantree lpthreshold
The Loop Protect event threshold value is 4
clear spantree lpthreshold
UsethiscommandtoreturntheLoopProtecteventthresholdtoitsdefaultvalueof3.
Syntax
clear spantree lpthreshold
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoresettheLoopProtecteventthresholdtothedefaultof3:
G3(rw)->clear spantree lpthreshold