Enterasys G3G170-24 - Clear Port Jumbo; Set Port Jumbo

set port jumbo
Enterasys G-Series CLI Reference 4-13
Defaults
Ifport‐stringisnotspecified,jumboframesupportstatusforallportswilldisplay.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaythestatusofjumboframesupportforge.1.1:
G3(su)->show port jumbo ge.1.1
Port Number Jumbo Status Max Frame Size
------------- --------------- ------------------
ge.1.1 Enable 9216
set port jumbo
Usethiscommandtoenableordisablejumboframesupportononeormoreports.
Syntax
set port jumbo {enable | disable}[port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,jumboframesupportwillbeenabledordisabledonallports.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoenablejumboframesupportforGigabitEthernetport14inslot3:
G3(su)->set port jumbo enable ge.3.14
clear port jumbo
Usethiscommandtoresetjumboframesupportstatustoenabledononeormoreports.
Syntax
clear port jumbo [port-string]
enable|disable Enablesordisablesjumboframe support.
port‐string (Optional)Specifiestheport(s)onwhichtodisableorenablejumbo
framesupport.Foradetaileddescriptionofpossibleport‐stringvalues,
referto“PortStringSyntaxUsedintheCLI”onpage4‐1.