Enterasys G3G170-24 - Show Multiauth Session-Timeout

show multiauth session-timeout
Enterasys G-Series CLI Reference 20-39
Parameters
Defaults
Ifnoauthenticationmethodisspecified,theidletimeoutvalueisresettoitsdefaultvalueof0for
allauthenticationmethods.
Mode
Switchmode,read‐write.
Example
Thisexampleresetstheidletimeoutvalueforallauthenticationm ethodsto0seconds.
G3(su)->clear multiauth idle-timeout
show multiauth session-timeout
Usethiscommandtodisplaythesessiontimeoutvalue,inseconds,forallauthenticationmethods.
Syntax
show multiauth session-timeout
Parameters
None.
Defaults
None.
Mode
Switchmode,read‐only.
Example
Thisexampledisplaysthesessiontimeoutvaluesforallauthenticationmethods.
G3(su)->show multiauth session-timeout
Authentication type Timeout (sec)
------------------- -------------
dot1x 0
pwa 0
mac 0
dot1x (Optional)SpecifiestheIEEE802.1Xport‐basednetworkaccesscontrol
authenticationmethodforwhichtoresetthetimeoutvaluetoits
default.
mac (Optional)SpecifiestheEnterasysMACauthenticationmethodfor 
whichtoresetthetimeoutvaluetoitsdefault.
pwa (Optional)SpecifiestheEnterasysPortWebAuthenticationmethodfor
whichto
resetthetimeoutvaluetoitsdefault.