Enterasys G3G170-24 - Reverting to a Previous Image; Reviewing and Selecting a Boot Firmware Image; Purpose; Commands

Reviewing and Selecting a Boot Firmware Image
Enterasys G-Series CLI Reference 2-37
7. Fromthebootmenuoptionsscreen,type2todisplaythebaudrateselectionscreenagain.
8. Type4settheswitchbaudrateto9600.Thefollowingmessagedisplays:
Setting baud rate to 9600, you must change your terminal baud rate.
9. Settheterminalbaudrateto9600andpressENTER.
10. Fromthebootmenuoptionsscreen,type1tostartthenewoperationalcode.Thefollowing
messagedisplays:
Operational Code Date: Tue Jun 29 08:34:05 2004
Uncompressing.....
Reverting to a Previous Image
Intheeventthatyouneedtodowngradetoapreviousversionofcode,youcandosoby
completingthefollowingstepsdescribedinthischapter.
1. Saveyourconfiguration,asdescribedin“saveconfig”(page 2‐43).
2. Loadyourpreviousversionofcodeonthedevice,asdescribedin“Downloadinga
Firmware
Image”(page 2‐35).
3. Setthisolderversionofcodetobethebootcode,asdescribedin“ReviewingandSelectinga
BootFirmwareImage”(page 2‐37).
4. Reloadthesavedconfigurationontothedeviceasdescribedin“configure”(page 2‐46).
Reviewing and Selecting a Boot Firmware Image
Purpose
Todisplayandsettheimagefiletheswitchloadsatstartup.TheG3switchallowsyouto
downloadandstoreabackupimage,whichcanbeselectedasthestartupimagebyusingthe
commandsdescribedinthissection.
Commands
Thecommandsusedtoreviewandselecttheswitch’sbootimagefilearelistedbelow.
show boot system
Usethiscommandtodisplaythefirmwareimagetheswitchloadsatstartup.
Note: You will not be able to peform these steps remotely unless you have remote console support.
For information about... Refer to page...
show boot system 2-37
set boot system 2-38