Enterasys G3G170-24 - Commands; Show Garp Timer; Show Gvrp

show gvrp
7-20 802.1Q VLAN Configuration
settings(enableordisable)andtimersettings.Bydefault,GVRPisenabledgloballyonthedevice,
butdisabledonallports.
Commands
show gvrp
UsethiscommandtodisplayGVRPconfigurationinformation.
Syntax
show gvrp [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,GVRPconfigurationinformationwillbedisplayedforallportsand
thedevice.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayGVRPstatusforthedeviceandforfw.2.1:
G3(su)->show gvrp ge.2.1
Global GVRP status is enabled.
Port Number GVRP status
----------- -----------
ge.2.1 disabled
show garp timer
UsethiscommandtodisplayGARPtimervaluesforoneormoreports.
Syntax
show garp timer [port-string]
For information about... Refer to page...
show gvrp 7-20
show garp timer 7-20
set gvrp 7-22
clear gvrp 7-22
set garp timer 7-23
port‐string (Optional)DisplaysGVRPconfigurationinformationforspeci ficport(s).For
adetaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐1.