Enterasys G3G170-24 - Show Ip Vrrp; Configuring PIM-SM; Purpose

show ip vrrp
Enterasys G-Series CLI Reference 16-45
show ip vrrp
UsethiscommandtodisplayVRRProutinginformation.
Syntax
show ip vrrp
Parameters
None.
Defaults
None.
Mode
Anyroutermode.
Example
ThisexampleshowshowtodisplayVRRPinformation
G3(su)->router(Config)#show ip vrrp
-----------VRRP CONFIGURATION-----------
Vlan Vrid State Owner AssocIpAddr Priority
2 1 Initialize 0 25.25.2.1 100
Configuring PIM-SM
Purpose
ToenableandconfigureProtocolIndependentMulticastinSparseMode(PIM‐SM).Thisprotocol
providesthemeansofdynamicallylearninghowtoforwardmulticasttrafficinan environment
wheregroupmembersaresparselylocatedthroughoutthenetworkandbandwidthislimited.In
situationswheremembersaredenselylocatedandbandwidthis
plentiful,DVMRPwouldsuffice
(see“ConfiguringDVMRP”onpage16‐31.)
PIM‐SMdeterminesthenetworktopologyusingtheunderlyingunicastroutingprotocoltobuild
aMulticastRoutingInformationBase(MRIB).
* Advanced License Required *
PIM is an advanced routing feature that must be enabled with a license key. If you have purchased an
advanced license key, and have enabled routing on the device, you must activate your license as described
in “Activating Licensed Features” on page 2-27.in order to enable the PIM command set. If you wish to
purchase an advanced routing license, contact Enterasys Networks Sales.
Note: IGMP must be enabled on all VLANs running PIM-SM, and must also be globally enabled
on the G-Series. For details on enabling IGMP, refer to Chapter 10.