Enterasys G3G170-24 - Page 388

set rmon stats
12-4 RMON Configuration
Example
ThisexampleshowshowtodisplayRMONstatisticsforGigabitEthernetport1inswitch1.
:
G3(su)->show rmon stats ge.1.1
Port: ge.1.1
-------------------------------------
Index = 1
Owner = monitor
Data Source = ifIndex.1
Drop Events = 0 Packets = 0
Collisions = 0 Octets = 0
Jabbers = 0 0 - 64 Octets = 0
Broadcast Pkts = 0 65 - 127 Octets = 0
Multicast Pkts = 0 128 - 255 Octets = 0
CRC Errors = 0 256 - 511 Octets = 0
Undersize Pkts = 0 512 - 1023 Octets = 0
Oversize Pkts = 0 1024 - 1518 Octets = 0
Fragments = 0
Table 12‐2providesanexplanationofthecommandoutput.
set rmon stats
UsethiscommandtoconfigureanRMONstatisticsentry.
Syntax
set rmon stats index port-string [owner]
Parameters
Defaults
Ifownerisnotspecified,monitorwillbeapplied.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoconfigureRMONstatisticsentry2forge.1.20:
G3(rw)->set rmon stats 2 ge.1.20
index Specifiesanindexforthisstatisticsentry.
port‐string Specifiesport(s)towhichthisentrywillbeassigned.
owner (Optional)Assignsanownerforthisentry.