Enabling Router Configuration Modes
Enterasys G-Series CLI Reference 14-3
Router Configuration
Mode
Set IP protocol
parameters.
Type router and the
protocol name (and, for
OSPF, the instance ID)
from Global or Interface
Configuration mode.
G3(su)->router(Config-router)#
Note: To jump to a lower configuration mode, type exit at the command prompt. To revert back to
switch CLI, type exit from Privileged EXEC router mode.
Table 14-2 Router CLI Configuration Modes (Continued)
Use this mode... To... Access method... Resulting Prompt...
To Next Page
Loading...
