Link Speed & Duplex:
Select an appropriate Ethernet speed and duplex setting. If you select a setting other than Auto,
make sure the setting corresponds to the settings on the hub you are using.
Redirect HTTP to HTTPS:
Enables or disables redirecting from HTTP to HTTPS.
Disable IPsec/IP Filtering:
Disables the IPsec/IP
ltering
setting.
Disable IEEE802.1X:
Disables the IEEE802.1X setting.
iBeacon Transmission:
Select whether to enable or disable the iBeacon transmission function. When enabled, you can
search for the printer from iBeacon-enabled devices.
Related Information
& “Making Wi-Fi Settings by Entering the SSID and Password” on page 53
& “Making Wi-Fi Settings by Push Button Setup (WPS)” on page 54
& “Making Wi-Fi Settings by PIN Code Setup (WPS)” on page 55
& “Checking the Printer's Network Connection Status (Network Connection Report)” on page 280
Web Service Settings
Select the menus on the control panel as described below.
Settings > General Settings > Web Service Settings
Epson Connect Services:
Displays whether the printer is registered and connected to Epson Connect.
You can register to the service by selecting Register and follow the instructions.
For usage guides, see the following portal website.
https://www.epsonconnect.com/
http://www.epsonconnect.eu (Europe only)
When you have registered, you can change the following settings.
Suspend/Resume:
Select whether to suspend or resume Epson Connect services.
Unregister:
Unregisters the printer from Epson Connect services.
Product Information
>
Settings Menu List
>
General Settings
376
To Next Page
Loading...
Need help?
General
