8. Vector Chart Material
8-57
How to display coverage of a Base or Update CD-ROM from an RENC
Insert desired CD-ROM into CD-ROM drive. Open the Chart menu then select Load or Update Charts followed
by from CD-ROM.
kn
kn
kn
+
60
°
03.400'N 1.453 NM
024
°
58.372'E 352.0
°
HDG (MAN) 289.0°
SPD (MAN) 0.0kn
SB (MAN) 0.0kn
COG (MAN) 289.0°
SOG (MAN) 0.0kn
Sample coverage area when a CD-ROM catalogue is from a Base CD-ROM from an RENC
Note 1: Uncheck "Missing only" to see total content of CD-ROM.
Note 2: Check "Permit" to show only the cells that have a permit. These cells are colored magenta. Then, when you
load a chart, only the cells that have a permit are loaded. During loading, these cells are colored blue. After the chart
is SENC-converted, the color of the cells becomes green.
To show all cells, uncheck "Permit". Then, cells with permits are magenta and those without permits are red. When
you load all cells, the color of all cells is blue. After SENC conversion, cells with permits are green and those
without permits are blue.
We recommend that you check "Permit" before loading a chart. This decreases loading time and you can soon know
what cells can be used.
Note 3: When you update a chart, check "Missing only". The ECDIS loads only those cells that it does not already
have. During the updating, cells are colored orange. After SENC conversion, the cells become green.
To Next Page
Loading...
