Furuno FEA-2807 - How to Change Other Waypoint Data; How to Add a New Waypoint at the End of a Route

13. Route Planning
13-11
How to drag and drop a waypoint to a new position
1. Click Route in the information area then click the Plan button to open the Plan Route dialog box. Click the
WPT tab to open the WPT page.
2. Check Enable changes then put the cursor on the waypoint you want to process.
3. Press and hold down the left mouse button while rolling the trackball to move the cursor to a desired position.
Keep the button pressed down while you move the cursor and release it when the cursor is at desired position.
LAT LON Mode RAD/NM CH lim/m MIN/l\kn MAX/kn
WPT
WPT
WPT count
Delete WPT
Alerts
Adjust after
(WT)
4. Drag and drop waypoint to next WPT position (in this case waypoint number 9 is taken to a next WPT
position).
13.5.3 How to change other waypoint data
To change other data of a waypoint, such as name, steering mode, turning radius, min/max speed, do the following:
1. Put the cursor on a desired field and spin the scrollwheel to change data.
2. Push the scrollwheel to confirm changes.
13.5.4 How to add a new waypoint at the end of a route
There are two ways that you can add a new waypoint at the end of a route:
• Use the cursor and left mouse button to define position of a waypoint.
• Use the Adjust after button in the WPT page.
To add a new waypoint by using the left mouse button, do the following:
1. Click Route in the information area then click the Plan button to open the Plan Route dialog box. Click the
WPT tab to open the WPT page. Check Enable changes.
2. Put the cursor in the electronic chart area on the location desired for a waypoint then push the left mouse button.
The waypoint is added at the end of route.
3. Modify data of added waypoint. See section 13.5.3 "How to change other waypoint data" for the procedure.
To add a new waypoint by the Insert after button, do the following: