Furuno FEA-2807 - How to Modify Chart Objects

10. Manual Updates
10-13
10.6.3 How to modify chart objects
The mariner cannot permanently remove from the chart display any of the official chart objects, but he can modify
position and/or properties of chart objects. When the mariner modifies a chart object, the ECDIS will mark original
chart object as deleted and a copy of original chart object as inserted.
1. Follow steps 1-3 on page 10-6 to display the Manual Update Planning dialog box.
2. Click the Modify button.
3. Put the cursor on the desired object then push the left mouse button.
4. Select the object from the Objects by Cell window. Confirm data for selected object.
5. Click the Accept button.
6. Click the Edit Properties button.
7. If you want to modify the position of the object, click the Edit Position button. Otherwise continue from step 13.
8. Put the cursor on the desired location on the ECDIS display, push left button then click the Accept button.
Repeat this until you have defined all points.
9. Click the Accept button on the Master/Slaves window.
10. Click the Accept Manual Updates as Permanent button. If you want to modify also properties continue from
step 10.
11. If you want to modify properties, also click the Accept button.
12. If you want to modify the properties of the object click Edit Properties and values button. Otherwise continue
from step 9.
13. Pick from the list properties you want to modify and give them new values. You can also add new WPT
properties or remove old.
14. Click Accept List and values to continue from step 5 or 11 again. Otherwise continue from step 9.
2.
4.
5.
6.
3. Place cursor on
desired object and
press left mouse button.