Furuno FEA-2807 - A4.3.4 Chart Catalogue of C-MAP Charts

Appendix 4: C-MAP CM-93/3 Charts
AP-42
How to look for charts around your ship
You can use either true motion or relative motion. In the true motion mode, your ship moves until it reaches the true
motion reset borderline, where it jumps back to an opposite position on the screen based on ship’s course. In the
relative motion mode, your ship stays in a fixed position, while the chart moves on screen.
If, in the true motion mode, you reset own position with TM/CU Reset, your ship will immediately jump to the true
motion reset position.
If, in the true motion mode, you use ShipOffcenter, your ship will go to that position on screen and continue true
motion movement from that position. When it reaches the true motion reset borderline, it will automatically jump to
the true motion reset position.
If, in the relative motion mode, you reset own position with TM/CU Reset, your ship will immediately jump to the
true motion reset position and use that position as fixed position to stay on screen.
If you use relative motion, you can select a new fixed position for your ship by using ShipOffcenter.
Use Range - and Range+ to select desired chart scale.
A4.3.4 Chart catalogue of C-MAP charts
You can use the chart catalogue to graphically view content of loaded C-MAP database(s) into ECDIS.
1. Open the Chart menu and select Catalogue.
2. Select "Source of Chart Catalogue" as C-MAP. Use Navigation purpose selection to view desired charts.
1
2
3
4
+
60 ° 03.400'N 1.453 NM
024
° 58.372'E 352.0 °
3. Charts for which you possess a valid license are marked in green. Charts for which you have no license or the
license has expired are shown as red borderlines.
1. Source of Chart Catalogue
• CD: Display charts available in a named "CD".
• RENC: Display charts available from an RENC.
• SENC: Display charts stored in your hard disk in SENC format.
• C-MAP: Display charts of CM93 ed. 3 chart database stored on ECDIS.