8. Vector Chart Material
8-28
8.5.3 How to display status and setting viewing dates of S57 chart
cells and their updates
When you load S57 chart cell(s) and/or their updates, the system sets Display Until of S57 chart cell(s) as current
date of the system. To set Approve Until as current date of the system, you must open the Set Chart viewing dates
dialog box and perform Approve Until. You can view status and set viewing dates of S57 chart cells and their
updates.
Select Set Chart viewing dates from the Chart menu to show the Chart Viewing date window.
Recommended settings in Chart viewing date are:
• Sync Manual Update Dates: ON position
• All SENCs: ON position
SENC edt / upd: This column contains
edition/update status from "SENC", i.e., loaded and
converted in the ECDIS.
Updates Displ. until: "date until updates" is
displayed. You can enter desired date by using the
Display Until field. The number after the date shows
the number of updates for the displayed cell
(number of displayed updates / number of updates in
SENC format).
Updates Approv. until: View the Date Until
updates is approved. You can enter desired date by
using the Approve Until field (number of approved
updates / number of updates in SENC format).
The issue date of the Product List used is displayed
as "Latest RENC Product List". An RENC Product
List contains information about the charts stored in
RENC and the date when the Product List was
issued. If the ECDIS does not contain any Product
List, then the date of the Product List is displayed as
"—NVLD—".
The indication ">>>" means that a chart is not up-
to-date. The indication "<<<" means that SENC
contains newer information than the information in
an RENC Product List. (You may need to load
newer RENC Product List.) Cancelled charts are
indicated as "cancelled" instead of "edtn/updn". If an
SENC contains a cancelled chart, then the indication
">>>" is replaced with "XXX".
To Next Page
Loading...
