Appendix 4: C-MAP CM-93/3 Charts
AP-39
A4.3.2 How to select CM93/3 chart material to use
Do the procedure below to display CM93/3 charts in the ARCS mode.
1. Open the Chart menu and select Activate S57 chart.
2. Select Ignore Scale (use same scale as used on previously loaded CM93/3 chart) or Sync Scale (use scale
currently used for ARCS chart).
A4.3.3 How to select charts for viewing
How to select a chart from a catalogue
To select a chart for viewing from a catalogue, do the following:
1. Select Chart Catalogue from the Chart menu.
2. From the Chart Catalogue dialog box, use the cursor to select desired chart.
3. Click the Open button
.
4. To display the catalogue, spin the scrollwheel to display Menu/Info/Chart Menu in the mouse functions area then
push the right mouse button.
5. Spin the scrollwheel to select Chart Catalogue then push the scrollwheel.
To Next Page
Loading...
