Furuno FEA-2807 - How to Set Usage Rights as Plan

18. Common Reference System
18-7
18.3.3 How to set usage rights as "plan"
A workstation can be set to control only the planning mode. This means that a particular workstation is used to edit
route, user chart and Notes in the planning mode. Selection of Plan usage rights is done in the Installation
Parameters of the ECDIS by service personnel. The operator is not able to set these usage rights.
Note that a workstation selected for Plan usage rights still has full viewing
access to navigation sensors and to monitored routes, user charts, etc. This
is important because it allows that operator(s) can monitor navigation.
To verify configuration of the system in which a selected workstation has
usage rights set as Plan, do the following:
1. On the workstation for which you want to give Plan usage rights, put
the cursor below the Lost TGT alarm indication, confirm that Initial
Settings is shown in the mouse functions area then push the right mouse
button.
2. Check Usage rights and select Plan from the list box.
The indication PLAN appears at the lower right hand corner of the display.
NM