14. Route Monitoring
14-3
14.4 How to Select Final Waypoint
Normally you use the last waypoint in a monitored route as the final waypoint, and the ECDIS automatically does
this when you select the route to monitor. However, sometimes you may prefer to use some other waypoint as the
final waypoint of a monitored route.
To select a waypoint as final waypoint, do the following:
1. Click Route in the information area then click the Monitor button.
2. Put the cursor in the Final WPT box then spin the scrollwheel to select a waypoint.
3. Push the scrollwheel to confirm your selection.
14.5 How to Display Waypoint Information
You can display waypoint information for the monitored route by
clicking the Waypoints tab in the Monitor Route dialog box. This
information is printed from the route planning information made
for this voyage.
"To WPT" and "Next WPT" are indicated on this list.
ETD
ETA
Speed limit
setting
WPT
WPT
LAT
LON
SPD CSE M
Rad
NAME
Planned ETA (UTC+1)
To Next Page
Loading...
