Furuno FEA-2807 - Shared Operator Selections; Usage Rights; How to Set Usage Rights as Master

18. Common Reference System
18-5
18.2.3 Shared operator selections
The common reference system concept allows that some selections and settings made by an operator in one
workstation are transferred to the other workstation. These are as follows:
• Route, user chart and Notes in monitoring mode
• Selected sensors in SPD/CRS and POSN pages (including position alignment of your ship and gyro correction)
in the Sensors dialog box
• Settings for chart alerts and watch sector
• Settings of conditions for voyage and dangerous targets recordings
• Ship parameters (table of forwarding distance, optimization parameters and navigation parameters)
• Setting for position discrepancy limit
18.3 Usage Rights
A workstation can have different usage rights. Master and Multi (Slave) rights allow control of both planning and
monitoring modes and navigation sensors. Slave (Multi) and Plan usage rights allow only control of the planning
mode. Workstations can be set so that
• One has Master usage rights. The rest have Slave (Multi) or Plan usage rights.
• One or two have Multi (Slave) usage rights. The rest have Plan usage rights.
18.3.1 How to set usage rights as "master"
One single workstation can be selected to control the monitoring mode and navigation sensors. This means that this
particular workstation is used to select route, user chart and Notes for the monitoring mode.
To configure the system so one workstation has usage rights set as
Master, do the following:
1. Put the cursor below the Lost TGT alarm indication, confirm
that Initial Settings is shown in the mouse functions area then
push the right mouse button.
2. Check the Usage rights box and select Master from the List box.
3. The indication MASTER appears at the lower right hand corner
on the selected workstation.
4. The indication SLAVE appears at the lower right hand corner on
the other workstation.
NM