Appendix 5: C-MAP CM-93/2 Charts
AP-87
A5.5 How to Display Status and Date Dependency of
S57 Chart Cells and their Updates
When you load S57 chart cell(s) and/or their updates, the system sets Display Until of S57 chart cell(s) as current
date of the system. To set Approve Until as current date of the system, you must open the Set Chart viewing dates
window and set it there. You can view status and date dependency of S57 chart cells and their updates as follows:
1. Open the Chart menu, select Set Chart viewing dates from the menu then push the
scrollwheel.
2. The Set Chart viewing date window appears.
Recommended settings in this window are:
• Sync Manual Update Dates: ON position
• All SENCs: ON position
RENC edt / upd: The "RENC" column contains edition/update status from Product List.
SENC edt / upd: The "SENC" column contains edition/update status from "SENC", i.e., loaded and converted in
the ECDIS.
Updates displ. until: View the date until updates is displayed. You can enter desired date by using the Display
Until input box. The number after date shows the number of updates done for the displayed cell (number of
displayed updates/number of updates in SENC format).
Updates approv. until: View the date until updates is approved. You can enter desired date by using the Approve
Until input box (number of approved updates/number of updates in SENC format).
To Next Page
Loading...
