Furuno FEA-2807 - 27 Parameters Setup; Parameters; Parameter-Related Menus

27-1
27. Parameters Setup
27.1 Parameters
The Initial Settings menu in the Initial Settings dialog box contains the installation parameters, navigation
parameters and optimization parameters that define the configuration of the ECDIS and operative parameters that
are either used to control steering and navigation calculation or used during route planning.
To open the Initial Settings menu, do the following:
Function keys
Operation
X
Parameter backup
Digitizer
Backup and Restore
Installation parameters
Navigation parameters
X
Chart Alert parameters
Optimization parameters
X
Print Navigation parameters X
Print Optimization parameters X
Selftest
Standby
Presentation Library
Access Server and Diagnostic
X
Close
1. Put the cursor on the text SINGLE, PLAN,
SLAVE, MULTI or MASTER (whichever is
shown) on the lower right corner of the
information area, confirm that Initial Settings
appears in the mouse functions area, then push
the right mouse button to open the Initial
Settings dialog box.
2. Put the cursor on the triangle in the Initial
Settings dialog box to show the Initial Settings
menu.
27.1.1 Parameter-related menus
How to set time
Put the cursor on the date and time presentation on right-hand side of ECDIS
display.
• Use the left mouse button to display UTC time and local time alternately.
• Use the right mouse button to change time zone and/or time.
Note: The time zone field always shows the time difference between UTC time and
local time without adjustment for daylight savings time.
To set the time, the following conditions must be met:
• Kalman filter should be OFF.
• Turn off any track steering mode (GOTO WPT or GOTO Track).